Traffic Camera System With Detection Traffic Camera On Sale
Traffic Camera System
Traffic Camera System sensitivity level, factory setting is 3, suggest level <6. the sensitivity and setting should be appropriate. The higher the sensitivity, the more likely it is to cause false detection, if it is too low, it will easily lead to missed detection. Level 3 is an ideal grade. for our actual measurement. if you have a bad road condition, you can adjust to properly. Auto reset time is reserved. traffic camera system results in retention time (1s-9s). After the target is detected in the camera detection area. the signal of the wireless video camera detector output board will remain for the output keep time. if the output has Jitter, you can increase the time appropriately. and manual calibration reserved. Region 1- Region 8: 8 configurable detection area, select the corresponding area, click draw to enter the detection area configuration detection area to draw and explain.
The traffic cameras for sale detection area has the above four forms.
A: Normal state( with direction detection) suggest.
B. Normal state( without direction detection)
C. Detection area setting status( with direction detection)
D. Detection area setting status (without direction detection)
Double-click the detection area with the left mouse button to switch between the normal state and the edit state. as shown in the above figure AC and BD.
In the editing state, Double-click the midpoint circle of each edge( as shown by the red circle in figure E) to switch the detection direction, click the midpoint of the edge of the arrow to switch the direction detection and non-direction detection. In the editing state, the left mouse button is used to grab the end point of each edge( as shown by the red circle in F) so that the detection area can be adjusted in the form of a moving end point)In the ending state, drag the left mouse button to drag each edge ( as shown in the red line segment in G). That is, you can adjust the detection area by moving the edge. In the editing state, the left mouse button is used to drag the entire detection area( as shown in the red area in Figure H), that is, the detection area can be adjusted by moving the detection area).Note: After setting click save-save to the types of traffic cameras. send the parameter to the camera. Concerning about traffic camera system output setting. and detection 1-8 output setting. output enable, the tick is enabled. and output disable.now only presence output.
Video Detector Camera Tool Main Interface.
1. Menu Bar
2. The real-time image preview area
3. Detection area
4. Data transmission status indication
5. Real-time detection result display area.
6. System message area
7. System time/data
Video Detector Camera Output Board Protocol
Data bits: 8
Stop bits: 1
Flow control: None
Connection: 1. RS232 connection: 1/2 GND connect to traffic light GND,5.RX2. connect to the traffic controller.TX,6TX2 connect to traffic controller RX.